g
55
0 Clean the holes in the steam nozzle
and the inner part of the steam nozzle
(see „Cleaning the steam nozzle“,
page 45).
When the or function is
selected, the appliance does not
deliver coffee, but only water
• The ground coffee may be blocked in
the ground coffee filler.
0 Remove the ground coffee inside the
filler using a knife (see „Using pre-
ground coffee“, page 43) (Fig. 22). Then
clean the brewing unit and the inside
of the appliance (see „Cleaning the
brewing unit“, page 51)
When the button is pressed, the
appliance does not switch on
• The main switch at the back is not
switched on (fig. 8) or the appliance is
not plugged in.
0 Check that the main switch is in the "I“
position and that the power cable is
plugged into the mains socket.
The brewing unit cannot be removed
for cleaning
• The appliance is on. The brewing unit
can only be removed if the appliance is
off.
0 Turn the appliance off and remove the
brewing unit (see „Cleaning the brew-
ing unit“, page 51).
3
Important: The brewing unit can only
be removed if the appliance is turned
off with the ON/OFF key at the
front. It should not be disconnected
from the mains. Attempting to
remove the brewing unit when the
appliance is on may cause serious
damage.
The coffee does not run out from
the dispenser outlets, but from
around the sides of the service door
• The holes in the dispenser outlets are
clogged with dry coffee.
0 Remove the dried coffee with a needle
(Fig. 29).
• The tilt compartment (R) inside the ser-
vice door is blocked and cannot swing.
0 Thoroughly clean the tilt compartment,
particularly near the hinges, to ensure
they are free to swing smoothly.
Ground coffee was used (not beans)
and the appliance does not deliver
any coffee
• Too much ground coffee has been
added.
0 Remove the brewing unit and thor-
oughly clean the inside of the appli-
ance, as described in „Cleaning the
brewing unit“, page 51. Repeat the
operation using a maximum of 2
scoops of ground coffee.
• The "Coffee strength / Pre-ground cof-
fee" knob has not been turned to the
or position and the appliance
has used both the ground coffee that
has been added and the coffee that has
been ground by the grinder.
0 Thoroughly clean the inside of the
appliance, as described in „Cleaning
the brewing unit“, page 51. Repeat the
operation, first turning the "Coffee
strength / Pre-ground coffee" knob as
described in „Using pre-ground cof-
fee“, page 43.
• Ground coffee has been added when
the appliance was switched off.
0 Remove the brewing unit and thor-
oughly clean the inside of the appli-
ance, as described in the section
„Cleaning the brewing unit“, page 51.
Repeat the operation, but switch the
appliance on first.
What to do if the coffee machine
has to be transported
• Keep the original packaging as trans-
port protection. It is important to use
the original plastic bag as a protection
against scratches.
• Secure the coffee machine and the
thermos jug against jarring. The manu-
facturer accepts no liability for dam-
age during transportation.
822_949_381 ECG6400_Elux.book Seite 55 Freitag, 6. Juli 2007 7:21 19
England 
Deutschland 
France 
Italia 
Polska 
United Kingdom 
Россия 
Nederland 
España 
Magyarország 
Sverige 
România 
Portugal 
Colombia 
Suomi 
New Zealand 
Česká republika 
Türkiye 
Danmark 
日本